hoffmann1320's profile - activity

Yes it is, I will try to change the terminal unit names to see if that is the problem

VRF Sever Warning In the error log for my model there is this severe error: Severe * InitVRF: VRF Terminal Unit = [

I am relatively new to Openstudio, what does that mean exactly?

I tried to use the zone report measure from the link in the answer, and continue to to fail the simulation becuase of th

We have already design the pv system, but are trying the see how the pv will affect the utility demand measurement in th

What are the inputs for this system? I am currently trying to model it this ,but experience a large amount of heating lo

Photovoltaic Modeling in Openstudio Trying to model a pv system to determine the affect of an onsite renewable generatio

Baseline System 9 Heated Only Warehouse Space Currently trying to model Warehouse spaces that have a constant thermostat

Surface Conductance Report Looking for a measure that outputs a report that overviews the building peak load components.

Click the detailed reports button next to the refresh button at the top right corner of the page.

https://drive.google.com/drive/folders/1aRqIeLFO_V8septVLYVKbnKLiN7kvDb1

IP units and Version 2.3.0

Open Studio DView Error I am trying to access the detailed reports for the output variables in an energy model, but afte

Open Studio DView Error I am trying to access the detailed reports for the output variables in an energy model, but afte

Would you need to apply a Follow Outdoor Air Temp setpoint manager too? I am working on a BL System 4 model and experien

PTHP- Supplemental Heat Control Currently Modeling a Baseline system 4 hvac system, which is depicted below. Im trying t

Where is the input for this field in openstudio? I am currently modeling a supplemental heat coil for a PTHP baseline sy

All of the heated only spaces except for 2(restrooms) are above the heated space criteria for climate zone 4 in table 3.

All of the heated only spaces except for two (restrooms) are above the Heated space criteria of 15 btuh/sf for climate z

Baseline Systems- System 4 heated only Spaces Currently modeling a baseline building that requires system 4 from Ashrae

Electric System: VAV reheat high heating load Energy modeling a building that contains a packaged rooftop dx coil electr

Thank you for your help, greatly appreciated. By doing, my heating load was brought way down, but still seems a little h

Where would you put the reset setpoint manager within the air loop? Would it be next to the VAV with reheat terminals?

That is because I already changed the peak flow rate of the fixtures to .1 and .15 and the flow fraction schedule to 1 h

https://drive.google.com/open?id=1cr0rOn8anWc-QTGDhYhnN7io0lJKnIcI here is the link to the file in a compressed zip fil

Open Studio (1x) 1.5gpm (11x)- 1 gpm When I decrease the peak flow rate by ten it reduces by 10x, but i also had to re

Open Studio (1x) 1.5gpm (11x)- 1 gpm When I decrease the peak flow rate by ten it reduces by 10x, but i also had to re

Service Hot water Usage I am designing the hotwater fixtures for a project that uses lav sinks at 1 gpm and a kitchenett

Choosing a Setpoint manager? I am currently trying to model a 10,000 sf community center in climate zone 4a that uses a