r.abbasinejad's profile - activity

Thank you very much Denis. By your guidance and correcting the geometrical mistakes, the geometry problem has been solve

Based on one experiment for daylight harvesting E+ results are different from what obtained by EN 15193 and DIALux. why?

I want to model a cubic room with walls faced north, west, south, and east. The room dimension is 5x5x2.7 m. with a window fully covered the north wall. I have no additional software such as sketch up, open studio, or etc. I entered all data by hand to idf editor After hundreds times of trying I was successful to receive output from the energy plus but still the room surfaces have not edge on another surface. Can somebody help me what are vertices and starting coordinates for each of surfaces? Thank you.

Could you please let me know your data for GlobalGeometryRules. Thank you very much.

Hi Denis Could you please give me your email address or either type of fast and efficient contact? Then I can send you t

Another thing please please tell me data for GlobalGeometryRules. Thank you very much

What do you think?

Hi Denis. Thank you very much for your detailed guidance. I tried your recommendations and now the file became as: IDF,W

Roof information: IDF,Roof,Roof,Roof_Construction,Zone 1,0,0,0,5,2.7,5,5; and IDF,RoofCeiling:Detailed,Roof_Ceiling,Roo

Walls information: IDF,Wall:Exterior, North wall ext,Walls_Construction,Zone 1,0,90,0,5,0,5,2.7;Wall:Exterior, East wal

Hi Denis Thank you for your reply. I use Energy plus 8.9.0 and the IDF file data for room surfaces are such as following

I need to find correct vertex and starting coordinates values I want to model a cubic room with walls faced north, west,