Elisa Matar's profile - activity

Hi, Keigo! In these cases I usually set z = 0 at 1F level and then change the boundary conditions of the walls that are

Energy Plus | View Factor to Sky-IR details Hi everyone! I was looking for Energy Plus outputs which could summarize ho

Energy Plus | View Factor to Sky-IR details Hi everyone! I was looking for Energy Plus outputs which could summarize ho

I was checking the annual chart for my fan energy results for some specific zone fans and I realized that even thought t

Avail. Manager Hybrid Ventilation - High Fan Energy Use Hi everyone! I'm using Energy Plus to simulate a large office b

Avail. Manager Hybrid Ventilation - High Fan Energy Use Hi everyone! I'm using Energy Plus to simulate a large office b

Natural Ventilation - Reasonable ACH results Hi all! I'm simulating a large office building which uses natural ventilat

Natural Ventilation - Reasonable ACH results Hi all! I'm simulating a large office building which uses natural ventilat

Great, I didn't know that! Now I've checked the meter section of the html and the multipliers are being considered there

The summary report accounts for the multipliers in the zone summary. But the total electric light energy use, both in th

Electric light output not accounting for zone multipliers Hi, everyone! I'm using zone multipliers to simulate a large

How to consider multipliers with hardsized systems? Hi, everyone! I'm using Open Studio/Energy Plus and I will need to

Yes, it works fine! No warnings about these interzone windows

AirflowNetwork - Interzone Windows Hi everyone! I am modeling a house with a interzone window using the AirflowNetwork

Yes, I am not familiar with VRFs either, but for me now it makes sense to group them. Thank you!

Right, it makes sense, thank you! In this case each of them has a sensor to adjust the refrigerant and air flows to wha

Right, it makes sense! In this case each of them has a sensor to adjust the refrigerant and air flows to what is needed

OpenStudio | Multiple terminal units providing outdoor air to 1 zone I need to model an office building in Open Studio,

Open Studio | Multiple VRF terminal units providing outdoor air I need to model an office building in Open Studio, serve

It's a requirement from the standard actually, to see how air temperature and thermal loads of the typical floor plan of

We are using EnergyPlus and editing the geometry in the idf directly with eppy, so that we can make it automatically. We

Heat transfer between floors placed at different heights In order to check compliance with a thermal comfort standard, w