Hello all, Is there a way in OS or EP to measure temperatures at specific points in modelled space? Say I have an office and wish to measure temperatures at a point next to the PC, window, door, etc. Would it be able to also get radiant heat, environment heat from the simulation?
I am new to this business and would appreciate your valuable answers.
Best,
This is a great question. I'll speak to the EnergyPlus side since that is the basis behind OpenStudio anyway.
Most simulations in EnergyPlus assume a well-mixed zone. This assumes that the entire air volume in a space can be represented by a single thermodynamic state, so the air near the wall is the same as the air in the middle of the room. In this case, no, a spatial temperature distribution is neither calculated, nor available for report. However, there are specialized room air models available that allow for stratified, or non-uniform, air temperature distribution in the space. Look up the options available in the docs here to learn about the differences. Each model allows different calculation capability, and thus different report variables, to allow output of temperatures at different locations within a space.
Cheers Edwin, From my limited knowledge of the matter. I would assume that off-the-shelf models are good middle solutions. Maybe adding an output variable browser in OS that addresses showing temperature distributions in 3D would be worthwhile. I would like to follow up that matter if OS has anything new regarding this issue. Thanks a lot for your response,
Asked: 9 years ago
Seen: 212 times
Last updated: Jul 24 '15
