First time here? Check out the Help page!
2018-10-30 14:23:03 -0500 | commented question | Energyplus Custom Meter for HVAC System If there is a topic on this discussion, can you forward me the topic? Thank you |
2018-10-30 14:21:48 -0500 | asked a question | Energyplus Custom Meter for HVAC System Energyplus Custom Meter for HVAC System Hi folks, I am looking for a solution for assigning different HVAC systems to d |
2018-07-25 17:56:51 -0500 | asked a question | eQUEST Furnace Preheat Coil Energy eQUEST Furnace Preheat Coil Energy Hi folks, I recently run into a situation that eQUEST doesn't count the natural gas c |
2015-06-11 13:14:52 -0500 | asked a question | OpenStudio VRF Total Heating/Cooling Rate VS Total Terminal Heating/Cooling Rate I have created a model for a one story building with four thermal zones in OpenStudio 1.7.0. VRF is the only HVAC system of this building. The heat recovery mode is turn on and all other setting are as default. I tried to understand how the heat recovery affect the total heating/cooling energy so I look into the comparison between total terminal heating/cooling rate and VRF heat pump total heating/cooling rate in detailed output variable mode. Based on the InputOutputReference, VRF Heat Pump Total Heating/Cooling Rate shall match the sum of the individual zone terminal unit output variable for Zone VRF Air Terminal Total Heating/Cooling Rate. However, I found that wasn't true for my model. The VRF Heat Pump Total Heating/Cooling Rate isn't equal to the sum of the individual zone terminal unit output variable for Zone VRF Air Terminal Total Heating/Cooling Rate at each timestep. Have anyone seen this situation before? Please help me understand what is wrong with my model. Thank you Chuangye |
2014-10-21 21:18:11 -0500 | received badge | ● Student (source) |
2014-10-21 21:12:05 -0500 | asked a question | OpenStudio SubMeter? I am new to OpenStudio and EnergyPlus. I want to have a sub-meter function in my OpenStudio model. I tried to look up a similar in OpenStudio but couldn't find any. The other method I tried is to create an exterior fuel equipment, and assign power and schedule to it. However, I couldn't find a way to do it in OpenStudio interface. Can you share your method to build a sub-meter function in OpenStudio? Or can you help me create the exterior fuel equipment in OpenStudio interface? |