First time here? Check out the Help page!
2020-01-13 14:48:02 -0500 | received badge | ● Popular Question (source) |
2017-02-06 05:29:59 -0500 | commented answer | How to set heating and cooling thermostat in Open studio? Hi David, Thanks a lot for your comment. Basically I got the power valution of the preliminary project, so far no systems are defined. I have to get the energy valuation by using Openstudio. After ran the simulation, the ResultsViewer shows "District Heating" and "District Cooling" values, I wonder if these values consist both energy for envelope and ventilation(In the load tab, people,lights,electric equipment, infiltrtion design flow rate are defined), but humidity. Thank you very much for your time. Chen |
2017-02-03 09:11:23 -0500 | received badge | ● Student (source) |
2017-02-03 09:01:47 -0500 | asked a question | How to set heating and cooling thermostat in Open studio? With Open studio, I set a simple model without using any HVAC system. In Results Summary, I got "Zone Air Tmeperature" chart runs from 18 °C to 28°C. I could not figure out where and how these values from. Adside from this, I tried to set a new "humidifying setpoint schedule", and drag it under the Thermal zone-Humidifying Setpoint schedule. But lauching the simulation, this option disapeared. Any solution for how to set constant indoor temperature and humidity? |
2017-02-03 09:01:47 -0500 | asked a question | How to keep indoor ttmperature and humidity constant without using system Dear all, I set a simple model without using any system. In Results Summary, I got "Zone Air Tmeperature" chart runs from 18 °C to 28°C. I could not figure out where and how these values from. Adside from this, I tried to set a new "humidifying setpoint schedule", and drag it in Thermal zone-Humidifying Setpoint schedule. But lauching the simulation, this option disapeared. Any solution for how to set indoor temperature and humidity? Thanks in advance. |