Revision history [back]

I have an installation where the fan-coils are heated by a WaterHeater:HeatPump. After performing the simulation, I verify that in the results of the energy comsuption appears in the watersystems group, what should I do so that the results of this heat pump appear in the heating group?

I have an installation where the fan-coils are heated by a WaterHeater:HeatPump. After performing the simulation, I verify that in the results of the energy comsuption appears in the watersystems group, what should I do so that the results of this heat pump appear in the heating group?

I have an installation where the fan-coils are heated by a WaterHeater:HeatPump. After performing the simulation, I verify that in the results of the energy comsuption consumption appears in the watersystems group, what should I do so that the results of this heat pump appear in the heating group?

I have an installation where the fan-coils are heated by a WaterHeater:HeatPump. After performing the simulation, I verify that in the results of the energy consumption appears in the watersystems group, what should I do so that the results of this heat pump appear in the heating group?

I have an installation where the fan-coils are heated by a WaterHeater:HeatPump. After performing the simulation, I verify that in the results of the energy consumption appears in the watersystems group, what should I do so that the results of this heat pump appear in the heating group?

I have an installation where the fan-coils are heated by a WaterHeater:HeatPump. After performing the simulation, I verify that in the results of the energy consumption appears in the watersystems group, what should I do so that the results of this heat pump appear in the heating group?

I have an installation where the fan-coils are heated by a WaterHeater:HeatPump. After performing the simulation, I verify that in the results of the energy consumption appears in the watersystems group, what should I do so that the results of this heat pump appear in the heating group?

I have an installation where the fan-coils are heated by a WaterHeater:HeatPump. After performing the simulation, I verify that in the results of the energy consumption appears in the watersystems group, what should I do so that the results of this heat pump appear in the heating group?