Question-and-Answer Resource for the Building Energy Modeling Community
Get started with the Help page
Ask Your Question

Revert fan flow back to normal after ems input

asked 2021-04-10 14:43:55 -0600

Martinsquare gravatar image

Via EMS, I want to adjust the fan air flow at some moments. I know how to adjust it. However, I can't figure out how to get it back to the orginal speed after the moments of fan increase via the ems. For simplification, I now have this.

    5 ZONE PVAV FAN,  
    Fan Air Mass Flow Rate

        IF (DayOfWeek ==2),    
        SET FANN=15,      

For this example, I want to increase the fan flow rate to 15 kg/s every 2nd day of the week. After the 2nd, day I want to revert it back to the speed what it would normally do. However, now it stays on 15 kg/s forever. I want it to go back to the default value after the 2nd day is finished. And this default value varies over time (depending on heating/cooling load), so it is not a constant value.

I hope someone can help.

edit retag flag offensive close merge delete

1 Answer

Sort by » oldest newest most voted

answered 2021-04-10 17:37:59 -0600

Please refer to the EnergyPlus EMS documentation on actuators where it says:

Actuators override things inside EnergyPlus whenever the actuator’s Erl variable is set to a value other than “Null.” Null is a special built-in variable used to deactivate an actuator. Once an actuator starts overriding, it will continue to do so until the actuator’s Erl variable is set to Null. You should set the actuators to Null whenever you want the EMS to revert to normal operation.

Thus, you should be able to do this:

      IF (DayOfWeek ==2),    
        SET FANN=15,      
        SET FANN=NULL,      
edit flag offensive delete link more

Your Answer

Please start posting anonymously - your entry will be published after you log in or create a new account.

Add Answer

Training Workshops

Question Tools

1 follower


Asked: 2021-04-10 14:43:55 -0600

Seen: 40 times

Last updated: Apr 10 '21