In the simulation summary report, the names of the zones are not shown, but some numbers [closed]

Question-and-Answer Resource for the Building Energy Modeling Community

Get started with the Help page

asked 4 years ago

Ruben
61 ●1 ●1 ●4

updated 4 years ago

1420 ●5 ●8 http://it.linkedin.com...

I am new in design builder and request support from the advanced ones. How do I recognize the zones by those numbers shown in the simulation summary report?

Closed for the following reason duplicate question by Ag
close date 2020-12-14 16:29:48.786357

add a comment

1 Answer

Sort by » oldest newest most voted

answered 4 years ago

1420 ●5 ●8 http://it.linkedin.com...

updated 4 years ago

Please go to Output tab in DesignBuilder and then check under General header when a zone is selected.

If you do not see Output tab, you have to go under Model Options > Simulation > Output and than chek Allow custom outputs

link

Comments

same question here

Ag ( 4 years ago )

add a comment

Training Workshops

Careers

Question Tools

1 follower

Stats

Asked: 4 years ago

Seen: 162 times

Last updated: Nov 18 '20

Site design and logo: Copyright © 2015 Big Ladder Software LLC. All rights reserved.
The Unmet Hours and Big Ladder names and logos are trademarks of Big Ladder Software LLC.
User contributions licensed under the Creative Commons Attribution Share Alike 3.0 License.

In the simulation summary report, the names of the zones are not shown, but some numbers [closed] savecancel

Closed for the following reason duplicate question by Ag close date 2020-12-14 16:29:48.786357

1 Answer

Comments

Training Workshops

Careers

Question Tools

Stats

In the simulation summary report, the names of the zones are not shown, but some numbers [closed]

Closed for the following reason duplicate question by Ag
close date 2020-12-14 16:29:48.786357