Can I use minisplit as a cooling equipment along with radiant hot water (boiler?) I can't figure out how to set up a system with hot water radiant and minisplit for cooling?
As you can see there is still a cooling load despite the error messages?
BEopt cannot model multiple pieces of equipment that both provide heating (or cooling). Since BEopt assumes that the mini-split will be providing both, it cannot be combined with a boiler. If you have a mini-split selected and then try to select a boiler (or vice versa), it will automatically deselect the other option to prevent two pieces of equipment providing heating.
That said, you could use BEopt to do two separate runs -- one with a mini-split and one with a boiler/AC -- and then combine the results using the cooling energy from the mini-split run and the heating energy from the boiler run.
I assume you are in the "Parametric" mode. You can switch to the "Design" mode and then right click on the "My Design" tab. There you can change the name of a single scenario and also create a new design with a proper name. When you run the analysis, the outputs will be shown based on the names you have assigned as opposed to Point 1, 2, etc. This can be a little bit inconvenient when there are multiple design scenarios but I think this is the only way to have the actual names on the output graphs.
Asked: 2019-06-05 09:56:42 -0600
Seen: 259 times
Last updated: Jun 05 '19
