Question-and-Answer Resource for the Building Energy Modeling Community

Loop Design Temperature Difference

asked 2016-05-14 11:23:38 -0600

812 ●2 ●12

I can´t find within openstudio where to specify the loop design temperature difference for sizing plants, either for a chilled water or cooling tower loop. The autosizing reports that I am getting are assuming a default of 19.80 degrees Fahrenheit to autosize the pump flow rate. After exporting an idf file I am able to specify plant sizing parameters within the energyplus idf editor. Is this something that is not available within the openstudio application? Or is there a way to specify it within openstudio?

edit retag flag offensive close merge delete

add a comment

1 Answer

Sort by » oldest newest most voted

answered 2016-05-15 08:26:58 -0600

MatthewSteen

10147 ●19 ●26 https://www.nrel.gov/b...

updated 2016-05-15 08:28:18 -0600

The Plant:Loop and Sizing:Plant objects can be edited by clicking on the dashed line separating the Supply Equipment and Demand Equipment of the PlantLoop.

edit flag offensive delete link

Comments

I just verified it. That´s correct. Thank you your answer Matthew! I was not aware of that.

Carlos Vazquez ( 2016-05-16 08:08:52 -0600 )edit

problem solved then, please mark the answer as accepted by clicking on the check mark next to the post (to the left)

Julien Marrec ( 2016-05-16 09:33:28 -0600 )edit

add a comment

Your Answer

Please start posting anonymously - your entry will be published after you log in or create a new account.

Add Answer

Training Workshops

Careers

Question Tools

1 follower

Stats

Asked: 2016-05-14 11:23:38 -0600

Seen: 1,748 times

Last updated: May 15 '16

Site design and logo: Copyright © 2015 Big Ladder Software LLC. All rights reserved.
The Unmet Hours and Big Ladder names and logos are trademarks of Big Ladder Software LLC.
User contributions licensed under the Creative Commons Attribution Share Alike 3.0 License.

Loop Design Temperature Difference edit