Two Setpoint Managers???

asked 2015-12-14 12:05:18 -0600

Dustin
1065 ●3 ●16

updated 2015-12-14 14:42:43 -0600

Hey all,

I am trying to get my simulation running and have been working through the errors. The error I am getting now is that I need to establish a setpoint at the humifier outlet node. This is the error.

* Severe * Humidifiers: Missing humidity setpoint for Humidifier:Steam:Electric = ELECTRIC HUMIDIFIER * ~~~ * use a Setpoint Manager with Control Variable = "MinimumHumidityRatio" to establish a setpoint at the humidifier outlet node.

So I understand I need to put a setpoint manager in but where can I place one in this model. I already have a setpoint manager for the temperature of the air leaving the entire unit. This air loop can be seen below.

image description

Edit: It should be noted that I cannot apply a setpoint manager humidity minimum because when I look in library the drop down menu is there but when I click it nothing shows up. image description

Edit: I can use a setpoint manager scheduled and change the control variable to Miniumum Humidity Ratio. Would the schedule then just be a fractional schedule?

edit retag flag offensive close merge delete

Comments

You should be able to see the SPM object under the "Library" list to drag and drop into your model. Once it's part of your model, then it may show up in the "My Model" list.

Aaron Boranian ( 2015-12-14 14:15:48 -0600 )edit

see my edit please. The setpoint manager is not even showing up.

Dustin ( 2015-12-14 14:34:26 -0600 )edit

Your schedule type for HumidityRatio control will be 'Dimensionless', not Fractional. This isn't well documented and I can't remember where I eventually found the requirement, I'll see if I can dig it up.

ericringold ( 2015-12-14 14:57:31 -0600 )edit

Thank you @Eric, I appreciate the response.

Dustin ( 2015-12-14 14:58:51 -0600 )edit

add a comment

m = OpenStudio::Plugin.model_manager.model_interface.openstudio_model node = m.getNodeByName("Node 42") setPM = OpenStudio::Model::SetpointManagerSingleZoneHumidityMinimum.new(m) setPM.addToNode(node)

Comments

Would this basically be the same thing that I described in my edit then? My understanding for my building is that they have a specific setpoint they want the humidity to be around, which is 27%. I understand that that may mean sending much lower or higher humidity supply air from the AHU. This is where I am getting confused as to what I should set the minimum humidity ratio leaving the unit as.

Dustin ( 2015-12-15 07:34:56 -0600 )edit

add a comment

Your Answer

Please start posting anonymously - your entry will be published after you log in or create a new account.

Two Setpoint Managers???

Comments

1 Answer

Comments

Your Answer

Training Workshops

Careers

Question Tools

Stats

Two Setpoint Managers??? edit

Comments

1 Answer

Comments

Your Answer

Training Workshops

Careers

Question Tools

Stats

Two Setpoint Managers???