First time here? Check out the Help page!
2019-12-04 05:14:33 -0500 | commented answer | Advice on modelling irregular bulkhead in DesignBuilder Thanks Chun, that helps me a lot! I just need to remember ro manually set these constructions whenever I make changes. I |
2019-12-04 05:07:26 -0500 | marked best answer | Advice on modelling irregular bulkhead in DesignBuilder Hi All, this is my first time posting here, but I have run into an issue with a new project I am involved in. We were asked to assess a library in terms of South African energy efficiency regulations, and the design has a fairly odd lightweight bulkhead design which tappers upwards towards the wall plate level in order to accommodate high level windows. Please see image here for clarity https://pasteboard.co/IIVIMVi.png At first I modeled it as a separate zone, but then DesignBuilder detects the tapered edges as internal walls. I figure it should be ok to just manually set those surfaces to the required construction, (Rhinoboard), but I don't know if this will skew results in any other way. My other thought is to model the bulkhead as a single component instead of a zone, but surely this must be a bad idea? Kind regards, Jadin |
2019-12-04 05:07:26 -0500 | received badge | ● Scholar (source) |
2019-12-04 05:04:46 -0500 | received badge | ● Supporter (source) |
2019-12-02 07:22:46 -0500 | received badge | ● Student (source) |
2019-12-02 06:08:44 -0500 | commented answer | Advice on modelling irregular bulkhead in DesignBuilder Hi Chun, thank you for your reply. I am using DB v4.7 since that is the highest approved version in SA. I don't think t |
2019-12-02 06:08:06 -0500 | answered a question | What are the reasons for abnormally long simulation time? You definitely have a very large amount of zones. What I have done, which is also the recommendation in the manual, is t |
2019-11-29 11:11:46 -0500 | asked a question | Advice on modelling irregular bulkhead in DesignBuilder Advice on modelling irregular bulkhead in DesignBuilder Hi All, this is my first time posting here, but I have run int |