Manuel's profile - activity

yes i saw, but even if i impost none for all, it returns me error on surface

I can not make it go. gives me errors: [12: 54: 53.930441 ERROR] Could not set argument 'footWallConstName' to value 'c

not yet. I have to click on apply measure. create a new one from the template. and make a paste copy of the link code in

the problem is created when I calculate the model without hvac systems. I have a supermarket as a model. 3 walls on 4 ag

the problem is created when I calculate the model without hvac systems. I have a supermarket as a model. 3 walls on 4 ag

Ground temperature in openstudio I wanted to change the ground temperature in openstudio. I saw in other posts that defa

compressor setpoint temperature abnormal electrical consumption I set a waterheater heat pump combined with a low temper

compressor setpoint temperature abnormal electrical consumption I set a waterheater heat pump combined with a low temper

compressor setpoint temperature abnormal electrical consumption I set a waterheater heat pump combined with a low temper

compressor setpoint temperature abnormal electrical consumption I set a waterheater heat pump combined with a low temper

Curve Fit tool problem in data output I used the spreadsheet, located in the energy plus installation folder, to calcula

I set the plant loop as the first two figure, the internal source as shown below, the setpoint manager like the following three figures. after running the simulation I have no fatal error and you can see a power consumption for heating, but looking at the indoor temperatures seems like nothing warms up. I'm sorry if i inserted too many images. someone has a suggestion to give me?

yes. thanks. now it's ok.

thnak you very much. i found it. i've never scroll in this tab.

but in openstudio where do I have to set these fields?

for information: the energy consumption is now half (58,2 kBtu)

I tried to delete the first three layers of the internal source and now it works. the internal temperatures follow the s

Hi, I'm just starting to learn openstudio so be patient. I modeled a residential building with radiator system and the simulation was successful. then I wanted to simulate a radiant floor, and I used the measure "AedgOfficeHvacRadiantDoas". I've seen that the measure has changed some things: - created internal source (on the tab Constructions) that i've added in interior surface. - (on the tab thermal zone) replaced with temperature radiant variable flow in the zone that there was "Zone HVAC Baseboard Rad Conv Water" - (on the tab HVAC systems) created 4 new plants loop, deleting the old plant loop - (on the tab schedule) created 8 new schedules for the new plant loop. the simulation failed and I tried to clear the two ventilation systems because I did not want to simulate this system. obviously the problem was not there, so the simulation failed again. can anyone help me? thank you very much

radiant floor simulation ok but wrong output I set the plant loop as the first two figure, the internal source

thanks avi. i've opened the file .err with notepad and i've seen that some surface with internal source haven't the same

the file eplusout (file mtd) is empty. the other file eplusout (.err, .end, ...) i cant'open. only the file run because

failed openstudio simulation with low temp radiant variable flow Hi, I'm just starting to learn openstudio so be patient

nothing, i've solved. my model had too much internal loads. i lowered some parameters.

Hi @simos @aparker, i've the same problem. How have you solved?