yhshaker2's profile - activity

I've been trying to run EP through windows command prompt, but it always crashes within less than a second.

The command I use is EnergyPlus -w weather.epw in.idf

The following is the text I get in the command prompt:

EnergyPlus Starting Energy Plus, Version 8.8.0-7c3bbe4830 Processing Data Dictionary Processing Input File **Fatal IP: Errors occurred on processing IDF file. Preceding condition(s) cause termination).

The error file contains the following errors * Severe * Out of range value Numeric Field#1 (REXT: R Value of any exterior insulation), value=0.00000, range={>0.0}, in GROUNDHEATTRANSFER:BASEMENT:INSULATION * Severe * IP: Out of "range" values found in input * Severe * IP: Out of "range" values and/or blank required fields found in input * Fatal * IP: Errors occurred on processing IDF file. Preceding condition(s) cause termination.

I tried running the file on EP-Launch, and it runs fine.

Yes I did. The idf file is fine. I've run it on EP-launch and it runs fine.

Issues running Energy Plus through Windows Command Prompt I've been trying to run EP through windows command prompt, but

I have been trying to use Euclid to edit an OpenStudio file. Euclid does not seem to have an option that allows you to import an OpenStudio file. Is there is a separate plug-in dedicated to editing OpenStudio models in sketch-up?

Which separate OpenStudio extension are you referring to that allows you to edit OpenStudio file geometry in Sketch-Up?

Can I edit an OpenStudio file in Euclid? I have been trying to use Euclid to edit an OpenStudio file. Euclid does not se