First time here? Check out the Help page!
2023-12-28 02:44:30 -0500 | received badge | ● Supporter (source) |
2019-12-23 02:22:52 -0500 | answered a question | Air Cooled Heat Pumps to Provide Chilled and Hot Water Usually i delete WaterHeater:Sizing and adjust Indirect Water Heating Recovery Time that is referenced to the DX coil. I |
2018-08-01 02:53:41 -0500 | answered a question | Heating equipment sizing and people load Hi, normally not accounting heat gain from people for heating sizing (so building equipment can met peak heating demand |
2018-05-10 04:23:31 -0500 | commented answer | Baseline G3.1.2.9: A term (pressure) In the title " input the design airflow rate" mean proposed airflow rate so I think you right in use your first rule. Us |
2018-05-10 04:18:25 -0500 | commented answer | Baseline G3.1.2.9: A term (pressure) In the title " input the design airflow rate" mean proposed airflow rate so I think you right in use your first rule. |
2018-05-10 04:05:56 -0500 | commented answer | Baseline G3.1.2.9: A term (pressure) Ok, now I understand the issue. You will take credit between pressure adjustment of devices (proposed vs baseline). For |
2018-05-10 04:01:32 -0500 | commented answer | Baseline G3.1.2.9: A term (pressure) Ok, now I understand the issue. For each pressure drop adjustment claimed, input the design airflow rate, CFMD, through |
2018-05-10 03:44:06 -0500 | commented answer | Baseline G3.1.2.9: A term (pressure) No trouble for air flow directly. Usually baseline airflow sizing is done with EnergyPlus Autosize with attention in set |
2018-05-10 03:00:50 -0500 | answered a question | Baseline G3.1.2.9: A term (pressure) "A" may be second rule. Proposed pressure may follow design data. Baseline may follow tab of pressure drop adjustment wi |
2018-01-08 12:42:09 -0500 | answered a question | what is the best way to modelling a multi story atrium building in design builder? I suggest to model the atrium as a single zone in a single storey block inserted in adjacence within the other floor blo |
2018-01-08 12:04:38 -0500 | commented question | How to integrate a Thermal Energy Storage in DesignBuilder? I usully adopt two solution for this: the first fast and which can run in DesignBuilder and the second more appropriate |
2017-12-15 10:21:44 -0500 | received badge | ● Teacher (source) |
2017-12-15 09:11:29 -0500 | answered a question | How to simulate BIPV on sun shade in DesignBuider? Design Builder export BIPV surfaces into IDF of Energy Plus leaving blank the Transmittance Schedule (=always opaque). S |