ArturoReyes's profile - activity

What can be causing a negative cooling load on VRF systems on Doas? I have a peculiar HVAC system on an OS 3.2 model whi

water cooled vrfs turning off causing low cooling consumption reported I have modeled a water cooled vrf system, It was

I followed all the suggestions above, and my idf file still shows the unmatched lists warning. Could this be causing my

Do I still need a DSOA for each zone if I set the Outdoor airflow rate during cooling, heating and no operation in my VR

Do I still need a DSOA for each zone if I set the Outdoor airflow rate during cooling, heating and no operation in my VR

It did solve the problem. Thank you very much!!!

Change Outdoor Air specification per zone in openstudio How can I specify individual Outdoor Air flows per zone in opens

Hello @mdahlhausen, Thanks for your response, I deleted all of the & and & characters, but the error remains.

Error while opening idf file from OS using energyplus I am trying to model water-cooled VRF systems, I have modeled ever

Error while opening idf file from OS using energyplus I am trying to model water-cooled VRF systems, I have modeled ever

Problem running baseline measure in openstudio when cooling tower present for LEED v3 model Hello everyone, I´m trying

Problem running baseline measure in openstudio when cooling tower present for LEED v3 model Hello everyone, I´m trying

Problem running baseline measure in openstudio when cooling tower present for LEED v3 model Hello everyone, I´m trying

Hello, You can use Ladybug tools for radiation studies and shading impact. It uses rhino- grasshopper as graphical inte

Thanks @David Goldwasser, I previously generated an OSM file from ladybugtools of a 7 story office building, including

replace VRF units with BCL components OpenStudio Hello, I want to know if it is possible to replace VRF autosized outdo

thanks for the response @MatthewSteen. I just tried that but sadly the error persists.

link text Here is the link, and the standards space types are as shown in the image: link text

From my initial model, they were all 0. But I have tried all combinations I could find in older posts for LED lights wit

Create Baseline Building measure error OpenStudio 2.8 Hello everyone, I am modeling a 7 story office building for LEED

Create Baseline Building measure error in OpenStudio 2.8 Hello everyone, I am working on a detailed LEED v3 model in Op

Hello, I am trying to design and simulate an earth tube to service a one story media library in Morelia, Mexico. Is it posible to simulate it in open studio? I normally use Honeybee in grasshopper.

Thank you in advance. Arturo