Question-and-Answer Resource for the Building Energy Modeling Community
Get started with the Help page
Ask Your Question

Revision history [back]

click to hide/show revision 1
initial version

asked 2021-06-18 12:01:23 -0600

ep_user's avatar

how to model parallel branch: HeatPump and Furnace?

I am trying to model a parallel branch for HeatPump and Furnace. But i am not sure how to connect them in EnergyPlus. The diagram is shown here. image description Is there any documents describing the similar way? Thanks.

click to hide/show revision 2
retagged

updated 2021-06-18 12:45:26 -0600

Aaron Boranian's avatar

how to model parallel branch: HeatPump and Furnace?

I am trying to model a parallel branch for HeatPump and Furnace. But i am not sure how to connect them in EnergyPlus. The diagram is shown here. image description Is there any documents describing the similar way? Thanks.

click to hide/show revision 3
retagged

updated 2021-06-22 10:23:19 -0600

__AmirRoth__'s avatar

how to model parallel branch: HeatPump and Furnace?

I am trying to model a parallel branch for HeatPump and Furnace. But i am not sure how to connect them in EnergyPlus. The diagram is shown here. image description Is there any documents describing the similar way? Thanks.

About | Help | Privacy | Legal | Contact
Site design and logo: Copyright © 2015 Big Ladder Software LLC. All rights reserved.
The Unmet Hours and Big Ladder names and logos are trademarks of Big Ladder Software LLC.
User contributions licensed under the Creative Commons Attribution Share Alike 3.0 License.
Powered by