Question-and-Answer Resource for the Building Energy Modeling Community
Get started with the Help page
Ask Your Question

Revision history [back]

click to hide/show revision 1
initial version

asked 2020-07-12 10:58:08 -0600

Li_Liu's avatar

Where can I find the error details for OpenStudio?

I loaded a DOE baseline model in OpenStudio. It runs OK. But when I tried to modify the setpoints in Schedules Tab, changed some of the temperature setpoints, it turns out failed like shown in the figure. I think it might because the setpoints I defined do not meet the restrictions by OpenStudio or something. But I don't know where can I find the error information to check the causes. Any ideas?

Any replay will be appreciated!

image description

Where can I find the error details for OpenStudio?

I loaded a DOE baseline model in OpenStudio. It runs OK. But when I tried to modify the setpoints in Schedules Tab, changed some of the temperature setpoints, it turns out failed like shown in the figure. I think it might because the setpoints I defined do not meet the restrictions by OpenStudio or something. But I don't know where can I find the error information to check the causes. Any ideas?

Any replay will be appreciated!

image description

About | Help | Privacy | Legal | Contact
Site design and logo: Copyright © 2015 Big Ladder Software LLC. All rights reserved.
The Unmet Hours and Big Ladder names and logos are trademarks of Big Ladder Software LLC.
User contributions licensed under the Creative Commons Attribution Share Alike 3.0 License.
Powered by