Question-and-Answer Resource for the Building Energy Modeling Community
Get started with the Help page
Ask Your Question

Revision history [back]

click to hide/show revision 1
initial version

asked 2015-03-16 05:31:37 -0600

Waseem's avatar

Schedule values interpolation

Hi,

I am trying to run a simulation with smaller time steps but this causes my schedule values to be 1 even if they are set as 0. I found out that this can be due to EnergyPlus trying to interpolate the schedule values. I could not find any field in my IDF where I have set Interpolate to either Yes or No Not even in Schedules.

Any idea why this is happening and how to fix this?

Thanks

Kindest Regards

Waseem

click to hide/show revision 2
retagged

updated 2015-07-11 19:59:44 -0600

__AmirRoth__'s avatar

Schedule values interpolation

Hi,

I am trying to run a simulation with smaller time steps but this causes my schedule values to be 1 even if they are set as 0. I found out that this can be due to EnergyPlus trying to interpolate the schedule values. I could not find any field in my IDF where I have set Interpolate to either Yes or No Not even in Schedules.

Any idea why this is happening and how to fix this?

Thanks

Kindest Regards

Waseem

About | Help | Privacy | Legal | Contact
Site design and logo: Copyright © 2015 Big Ladder Software LLC. All rights reserved.
The Unmet Hours and Big Ladder names and logos are trademarks of Big Ladder Software LLC.
User contributions licensed under the Creative Commons Attribution Share Alike 3.0 License.
Powered by