Revision history [back]

Hello All, I am using autosizing for hvac calculations in EnergyPlus. It gives me zero cooling load on summer design day. However, indoor temperature is much higher than the cooling setpoint on summer design day. The same day (i.e. summer design day) in the annual simulation is good (i.e. there is cooling load and indoor temperature is lower than the cooling setpoint). Any help would be appreciated.

Hello All, I am using autosizing for hvac calculations in EnergyPlus. It gives me zero cooling load on summer design day. However, indoor temperature is much higher than the cooling setpoint on summer design day. The same day (i.e. summer design day) in the annual simulation is good (i.e. there is cooling load and indoor temperature is lower than the cooling setpoint). Any help would be appreciated.