Question-and-Answer Resource for the Building Energy Modeling Community
Get started with the Help page
Ask Your Question

Revision history [back]

click to hide/show revision 1
initial version

error after run.... please help!!

I am using 1.11.1 openstudio and energyplus version is 8-5-0 my building consists of single story with attic, and i am not using ideal load or HVAC system, after I run the simulation i get 26 errors: 19 errors due to surface matching even the sketchup didn't show any errors after surface matching: ( i used matching tool and intersections for matching), however i noticed that all the errors are due to surface matching between the interior ceiling and the attic floor. C:\fakepath\2 error.JPG

and 7 other errors as shown in following figure: C:\fakepath\error.JPG

hope you kind cooperation to resolve these errors.

error after run.... please help!!

I am using 1.11.1 openstudio and energyplus version is 8-5-0 my building consists of single story with attic, and i am not using ideal load or HVAC system, after I run the simulation i get 26 errors: 19 errors due to surface matching even the sketchup didn't show any errors after surface matching: ( i used matching tool and intersections for matching), however i noticed that all the errors are due to surface matching between the interior ceiling and the attic floor. C:\fakepath\2 error.JPG

and 7 other errors as shown in following figure: C:\fakepath\error.JPG

hope you kind cooperation to resolve these errors.

error after run.... please help!!

I am using OpenStudio 1.11.1 openstudio and energyplus version is 8-5-0 8-5-0.

my building consists of single story with attic, and i I am not using ideal load or HVAC system, after I run the simulation i I get 26 errors: errors:

19 errors due to surface matching even the sketchup didn't show any errors after surface matching: ( i (I used matching tool and intersections for matching), however i I noticed that all the errors are due to surface matching between the interior ceiling and the attic floor. C:\fakepath\2 error.JPGfloor.

C:\fakepath\2 error.JPG

and 7 other errors as shown in following figure: C:\fakepath\error.JPGfigure:

hope you kind cooperation to resolve these errors.C:\fakepath\error.JPG

error after run.... please help!!

I am using OpenStudio 1.11.1 and energyplus version is 8-5-0.

my building consists of single story with attic, and I am not using ideal load or HVAC system, after I run the simulation I get 26 errors:

19 errors due to surface matching even the sketchup didn't show any errors after surface matching: (I used matching tool and intersections for matching), however I noticed that all the errors are due to surface matching between the interior ceiling and the attic floor.

C:\fakepath\2 error.JPG

and 7 other errors as shown in following figure:

C:\fakepath\error.JPG

error after run.... please help!!

I am using OpenStudio 1.11.1 and energyplus version is 8-5-0.

my building consists of single story with attic, and I am not using ideal load or HVAC system, after I run the simulation I get 26 errors:

19 errors due to surface matching even the sketchup didn't show any errors after surface matching: (I used matching tool and intersections for matching), however I noticed that all the errors are due to surface matching between the interior ceiling and the attic floor.

C:\fakepath\2 error.JPG

and 7 other errors as shown in following figure:

C:\fakepath\error.JPG