Question-and-Answer Resource for the Building Energy Modeling Community

Error in TRNsys comes up after increasing losses in collector

asked 2022-08-26 18:34:01 -0600

rezaafz
3 ●2

updated 2022-08-29 08:20:52 -0600

Aaron Boranian

14155 ●83 ●24 http://bigladdersoftware.com/

Hello

As I increase the value of "Loss coefficient for bottom and edge losses" of collector type 50d, from 4.1 to 4.3 (or more), once I run the simulation, the following error comes up: invalid floating operation.

Simulatoin Project The error message

What do you think the problem is? Thanks for your help!

edit retag flag offensive close merge delete

add a comment

1 Answer

Sort by » oldest newest most voted

answered 2022-08-30 09:40:14 -0600

Tim McDowell
651 ●3 ●2

The change in the parameter value is causing a illegal floating point operation in the code. It is impossible to know why from just looking at the picture of your project. You should contact your TRNSYS distributor for technical support on this issue.

edit flag offensive delete link

add a comment

Your Answer

Please start posting anonymously - your entry will be published after you log in or create a new account.

Add Answer

Training Workshops

Careers

Question Tools

1 follower

Stats

Asked: 2022-08-26 18:34:01 -0600

Seen: 152 times

Last updated: Aug 30 '22

Site design and logo: Copyright © 2015 Big Ladder Software LLC. All rights reserved.
The Unmet Hours and Big Ladder names and logos are trademarks of Big Ladder Software LLC.
User contributions licensed under the Creative Commons Attribution Share Alike 3.0 License.

Error in TRNsys comes up after increasing losses in collector edit