Error in Simulating the ZoneHVAC:LowTemperatureRadiant:VariableFlow (AutoSizing)

asked 2021-08-02 07:29:57 -0600

Engr.Samiullah's avatar

updated 2021-08-17 11:20:39 -0600

__AmirRoth__'s avatar

I am trying to simulate the ZoneHVAC:LowTemperatureRadiant:VariableFlow with autosizing on in OpenStudio. But getting this severe error "Hydronic radiant systems may not be autosized without specification of nodes or schedules" . Although , I have mentioned the both the nodes and schedules . I searched on net and found this thing "https://github.com/NREL/EnergyPlus/co..." but don't know how to use this and correct the source code of installed EnergyPlus and OpenStudio. Can anybody help me?

edit retag flag offensive close merge delete

Comments

The bugfix you referenced addresses this bug, which says that it's only an issue for cooling-only radiant systems. Do you have a cooling-only radiant system?

shorowit's avatar shorowit  ( 2021-08-03 11:59:52 -0600 )edit

Yes ; It is cooling-only radiant system

Engr.Samiullah's avatar Engr.Samiullah  ( 2021-08-03 12:04:57 -0600 )edit

Perhaps you could work around the issue by adding heating, but disable the heating from being available/used?

shorowit's avatar shorowit  ( 2021-08-03 12:07:54 -0600 )edit

For that , I have to specify the hot water loop . But I want to know direct solution of this bug.

Engr.Samiullah's avatar Engr.Samiullah  ( 2021-08-03 12:17:48 -0600 )edit

Mr. Shorowit can you help me on this

Engr.Samiullah's avatar Engr.Samiullah  ( 2021-08-14 11:53:46 -0600 )edit
add a comment