after changing the ceiling height the model got broken

asked 2021-04-13 08:28:39 -0600

Brianna's avatar

updated 2021-04-13 10:22:57 -0600

Hi I was trying to changing the ceiling height by moving all the roof surface together But after I selected the roof and move the edges , some of the points are still stay where they are before image description \

I am following those steps shown in the video but got different results Did I miss any important steps ? https://www.youtube.com/watch?v=a8tNq... Thank you in advance

edit retag flag offensive close merge delete

Comments

That video shows specialized case to move ceilings from multiple spaces at the same time. If you are just trying to do this for a single surface then try using SketchUp's push/pull tool on the roof surface, no selection of edges required.

David Goldwasser's avatar David Goldwasser  ( 2021-04-13 12:15:47 -0600 )edit

Hi David thank you for this timely reply ! I was actually trying to move all the roof, but the inner spaces got problem. So I took screenshot of it. the outside surface are ok

Brianna's avatar Brianna  ( 2021-04-13 13:21:49 -0600 )edit

Have you considered modelling that sloped surface as flat? Might make your life a lot easier.

Jono's avatar Jono  ( 2021-04-16 10:29:49 -0600 )edit

thank you Jono, when I selected the edges and moved them, there are some points didn't get moved together for some reason. But later I moved them manually to other edges

Brianna's avatar Brianna  ( 2021-04-19 21:20:59 -0600 )edit