Question-and-Answer Resource for the Building Energy Modeling Community
Get s tarted with the Help page
Ask Your Question
2

Warning: Calculated design heating load for zone is zero.

asked 2020-11-06 21:58:01 -0500

Arthur Portugal gravatar image

Hello my friends,

I have a problem with my simultion in EnergyPlus.

My building is locate in Mumbai, India. I'm using the system VRF for attend necessities of cooling in the design. My project need only cooling because mumbai is too hot whole year.

My intention is apply the parameters and the software calculate using autosize. In the thermost, it's necessary to specify a setpoint of heating but I don't need heating in my project.

When I simulate, there are a warnings about:

* Warning * Calculated design heating load for zone=4A61D4 is zero.

* ~~~ * Check Sizing:Zone and ZoneControl:Thermostat inputs.

Note: I use "Do Sizing Zone Calculation" on the SimulationControl.

How I can solve?

Thanks for attention.

edit retag flag offensive close merge delete

1 Answer

Sort by ยป oldest newest most voted
3

answered 2020-11-08 11:19:56 -0500

This is not a Severe or Fatal Error, only a Warning, and , as you say, totally expected.

Keep on with your simulation !

May you want to see this about error severity degree in energyplus

edit flag offensive delete link more

Your Answer

Please start posting anonymously - your entry will be published after you log in or create a new account.

Add Answer

 

Question Tools

1 follower

Stats

Asked: 2020-11-06 21:58:01 -0500

Seen: 103 times

Last updated: Nov 08 '20