I have a quetion between infiltration and ventilation. I'm modeling a building in OpenStudio and the building has natural ventilation. I added infiltration to the building using the method ''Space Infiltration Effective Leakage Area''. The question is: if I'm using ''Space Infiltration Effective Leakage Area'' am I modeling natural ventilation (directly from EnergyPlus) or is necessary to add ventilation to the zone?
EnergyPlus treats outdoor air entering a zone similarly whether it is from infiltration or natural ventilation.
However, infiltration values are typically far lower than what is needed to meet the ventilation requirement, so you'll need to add more natural ventilation. You can check this by reporting the infiltration air flow rate versus the ventilation requirement from your design specification outdoor air object.
The Add Wind and Stack Open Area OpenStudio measure on BCL approximates natural ventilation assuming you don't have significant inter-zone air transfer.
If you do have significant inter-zone air transfer you'll need to use the Airflow Network in EnergyPlus, and an EMS program if you have some sophisticated logic to turn the natural ventilation on/off.
I have applied the measure you recommended to me '' Add Wind and Stack Open Area '' but now the inside temperature in the night is more down than the outside temperature. I do not have any refigeration equiment inside the building. Other thign is that the ''zone mean aire dewpoint temperaure'' in the nigth is the same than the inside air temperature the building. do you know why this happens?. I do not know if it's because of a convection problem in the indoor air.
Asked: 2018-08-16 11:41:49 -0500
Seen: 565 times
Last updated: Aug 16 '18
