Heat Pump Modeling

asked 6 years ago

berling's avatar

updated 6 years ago

I keep getting Heating or Cooling Set Point errors in BEopt when I select a Heat Pump and the primary heating and cooling equipment. BEopt does not seem to think that the Air Source Heat pump can do both. Any comments on why this may happen?

Edit: 2.8.0.0 file attached. Actual Error: 4/19/2018 2:01 PM: 1.xml: Warning: The building has no cooling equipment but a cooling setpoint is specified; the simulation will proceed without a cooling system.

Thanks, Geoffrey

Preview: (hide)

Comments

Can you post the error messages and upload your project file?

shorowit's avatar shorowit  ( 6 years ago )

I edited the original post with the BEopt file and actual error.

berling's avatar berling  ( 6 years ago )

Did the file attach?

berling's avatar berling  ( 6 years ago )

@berling, I don't see an attached file.

Eric Wilson's avatar Eric Wilson  ( 6 years ago )

Thanks Eric, any suggestions to make it work. Each time I click attache and select the file it thinks for a second but nothing seems to happen.

berling's avatar berling  ( 6 years ago )