Problems to run the simulation [closed]

asked 2016-11-30 14:17:31 -0500

Flow78's avatar

updated 2016-12-02 13:10:27 -0500

Hi all,

I have many errors when I run the simulation but I don't understand the problems and I don't know how to resolve them. If someone can help me that can be very useful ! I copy-past the kind of errors I have.

CheckWarmupConvergence: Loads Initialization, Zone="AHU 4" did not converge after 25 warmup days. ...Environment(SizingPeriod)="BALTIMORE BLT WASHNGTN INTL ANN CLG .4% CONDNS WB=>MDB" ..Max Temp Comparison = 0.14 vs Temperature Convergence Tolerance=0.40 - Pass Convergence ..Min Temp Comparison = 3.79E-006 vs Temperature Convergence Tolerance=0.40 - Pass Convergence ..Max Heat Load Comparison = 0.0000 vs Loads Convergence Tolerance=4.00E-002 - Pass Convergence ..Max Cool Load Comparison = 0.5164 vs Loads Convergence Tolerance=4.00E-002 - Fail Convergence

UpdateZoneSizing: Cooling supply air temperature (calculated) within 2C of zone temperature ...check zone thermostat set point and design supply air temperatures ...zone name = AHU 1 ...design sensible cooling load = 812355.99 W ...thermostat set point temp = 0.000 C ...zone temperature = 26.809 C ...supply air temperature = 26.667 C ...temperature difference = -0.14226 C ...calculated volume flow rate = 4319975.64733 m3/s ...calculated mass flow rate = 5173659.00476 kg/s

Plant flows do not resolve -- splitter inlet flow does not match mixer outlet flow Environment=BALTIMORE BLT WASHNGTN INTL ANN CLG .4% CONDNS DP=>MDB, at Simulation time=07/21 00:00 - 01:00 PlantLoop name= CONDENSER WATER LOOP Plant Connector:Mixer name= CONDENSER WATER LOOP DEMAND MIXER Mixer outlet mass flow rate= 246067293.760194 {kg/s} Plant Connector:Splitter name= CONDENSER WATER LOOP DEMAND SPLITTER Splitter inlet mass flow rate= 246067293.760194 {kg/s} Difference in two mass flow rates= 2.980232E-008 {kg/s}

Thank you very much for your help !

edit retag flag offensive reopen merge delete

Closed for the following reason duplicate question by David Goldwasser
close date 2016-11-30 15:20:54.016194

Comments

Assuming your simulation is failing with a fatal error, it is a duplicate of this post.. If you are referring to warnings on a successful simulation, it would help if you asked just about a specific warning.

David Goldwasser's avatar David Goldwasser  ( 2016-11-30 15:20:46 -0500 )edit