Question-and-Answer Resource for the Building Energy Modeling Community

Warning - Calculated Relative Humidity out of range

asked 2014-12-05 12:43:43 -0500

nfonner
616 ●2 ●8

updated 2015-01-09 12:31:21 -0500

Neal Kruis

4675 ●9 ●17 http://bigladdersoftware.com/

I am constantly seeing this warning:

* Warning * Calculated Relative Humidity out of range (PsyRhFnTdbWPb) * ~~~ * Routine=CalcMultiSpeedDXCoil:lowspeedoutlet, Environment=RUN PERIOD 1, at Simulation time=04/12 13:00 - 13:10 * ~~~ * Dry-Bulb= 3.21 Humidity Ratio= 4.897E-003 Calculated Relative Humidity [%]= 101.01 * ~~~ * Relative Humidity being reset to 100.0%

Any thoughts on if this is something I can ignore?

edit retag flag offensive close merge delete

add a comment

1 Answer

Sort by » oldest newest most voted

answered 2014-12-05 14:13:05 -0500

MJWitte

9670 ●6 ●10 http://www.gard.com/

Hard to make a blanket comment without knowing more about what's happening in the model. A leaving dry-bulb temp of 3.2C (37.8F) is rather cold off a DX coil, so the airflow to capacity ratio for this coil may be too low.

edit flag offensive delete link

Comments

Looks like increasing the Constant Minimum Airflow Fraction above the minimum ventilation rate was part of the issue. The warning persists, but was much less "severe" at a DB to 9.48 C for that same model.

Thanks Michael.

nfonner ( 2014-12-05 14:58:48 -0500 )edit

add a comment

Your Answer

Please start posting anonymously - your entry will be published after you log in or create a new account.

Add Answer

Careers

Question Tools

1 follower

Stats

Asked: 2014-12-05 12:43:43 -0500

Seen: 443 times

Last updated: Dec 05 '14

Site design and logo: Copyright © 2015 Big Ladder Software LLC. All rights reserved.
The Unmet Hours and Big Ladder names and logos are trademarks of Big Ladder Software LLC.
User contributions licensed under the Creative Commons Attribution Share Alike 3.0 License.

Warning - Calculated Relative Humidity out of range edit