OpenStudio merged surfaces inside a thermal zone to internalmass

asked 2015-08-31 13:50:24 -0500

TiejunWu

553 ●1 ●8 http://www.carrier.com/

updated 2015-08-31 14:08:10 -0500

__AmirRoth__

4436 ●5 ●17 http://bleedinggreenna...

In OpenStudio when I assign multiple spaces into one thermal zone, in the exported IDF, the partition walls between these spaces gets merged into "InternalMass" in EnergyPlus. However, looks like the "SurfaceArea" of the InternalMass is only one wall area. Since EnergyPlus asks for the "total surface area exposed to the zone air" should that be two times the original wall area since both sides of the partition wall are exposed to the zone air?

answered 2015-09-01 09:08:12 -0500

David Goldwasser

20295 ●94 ●14 http://www.openstudio.net/

updated 2015-09-01 09:09:54 -0500

Good question. This sounded familiar to me, and looking back we did have an old issue filed about it https://github.com/NREL/OpenStudio/is...

Currently we do only model half the exposed area we should for the internal mass, but if we just double the area then we will have too much mass. Sounds like the best solution would be to double the area while at the same time altering the construction to cut down the mass. Maybe can just cut thickness of materials in half. A more complex solution would split the construction down the middle (or at least conductive layer) into two constructions.

edit flag offensive delete link

Comments

There is a related issue. This goes into more detail about other improvements to internal mass. Specifically it talks about combining all the internal mass objects within a zone that use the same construction into a single internal mass object to speed up simulation; but no single internal mass object should be bigger than half of the area of the heat transfer surfaces in a zone.

David Goldwasser ( 2015-09-01 09:20:06 -0500 )edit

add a comment

Your Answer

Please start posting anonymously - your entry will be published after you log in or create a new account.

OpenStudio merged surfaces inside a thermal zone to internalmass

1 Answer

Comments

Your Answer

Careers

Question Tools

Stats

OpenStudio merged surfaces inside a thermal zone to internalmass edit

1 Answer

Comments

Your Answer

Careers

Question Tools

Stats

OpenStudio merged surfaces inside a thermal zone to internalmass